Engraving machine repair

- Sep 08, 2018-

Can engrave a variety of relief, shadow carving, openwork, plane carving, cutting, washing and other effects. When the engraving machine is not working properly, it may be a problem with its internal components or other reasons. The following is a general introduction to the problems that often arise.

(1) One of the three axes cannot move. In this case, check if the corresponding drive block of the corresponding axis is damaged. The inspection method can use the replacement method: unplug the aviation plug corresponding to the fixed shaft and insert it into the drive corresponding to the other active shaft.

(2) If the non-moving axis moves normally after the exchange, it can be explained that the drive block corresponding to the shaft is damaged, and the drive block needs to be replaced. If the axis is not moving, it means that the cable or motor is faulty. Replace the cable or motor. The three axes cannot move. At this point, check if the three-axis aviation plug is connected to the control box and the control box power is turned on. Whether the data cable is connected to the control box and the control card in the computer mainframe. If all of the above are normal, please contact the factory.

(3) The spindle cannot operate normally. First check the error code displayed on the LED display of the inverter (see the inverter manual error code item).

Modification of the engraving machine parameters (Vihong system): Manufacturer parameter modification, (Enter password: NCSTUDIO click "OK") Workbench stroke: (depending on the model of the machine) System parameters: The first four items are based on the default All selected.

Motor parameters: 0.00625 if the lead is 10; 0.003125 if the lead is 5.

Z axis maximum speed: generally set at about 1000

Uniaxial acceleration: default value

Curved acceleration: the default value can be